I created this slice because the one in Sculpt Studio didn’t meet the edges of the slice. I found that by pushing the points to the edges (or shrinking the slice while in edit mode so that the points meet the edges), it is easier to predict how the size of your slices will affect your sculpt. […]
-
Recent Posts
Recent Comments
- Ghanie Lane on LESSON 2
- Katzuki_Wildcat on coordinate cross
- osirisacropolis on Where and How do I get an update
- Martin Glom on Fleur’s quick and dirty guide to Version 6 Part 3 – A New Balloon, I call it the Speed Balloon
- Martin Glom on Fleur’s quick and dirty guide to Version 6 Part 3 – A New Balloon, I call it the Speed Balloon
Keywords
arc architecture beginner bottle circle component cross cup dented Education flange flask frame fully explained Furniture HALF Circle heart hollow cylinder HUD introduction jewelery jewelry mikro Moka nano Notecard Parabolic Dish poles precision round rounded Screw screwdriver Sculpt sharp edges spiral square square sharp stairs Symmetrical tool torus-type triagle valentine vase wallLinks
Meta